Carbon Halogen Infrared Heaters: The Industrial Heat You Can Count On
We build carbon heater parts for the machines that need heat, fast. And not just a gentle warm-up—we’re talking about focused, direct heat that hits the spot and gets the job done. Our carbon halogen tubes deliver infrared energy right where you need it, so you’re heating the target, not the whole room.
Power, Voltage, and Size—Straight to the Point
These tubes are built for the heavy lifting. We spec them at 400V, which means you can run serious power over longer lines without the wiring turning into a mess. It keeps things clean and manageable. The tube is 300mm long, so the heat stays concentrated in a tight area. And with 2500W of output, you get the watt density needed to jump to operating temperature quickly. The result? A heat profile you can rely on, cycle after cycle.
Built to Take the Heat
The envelope is quartz—tough enough to handle extreme temperatures and sudden changes without cracking. Inside, the halogen gas does its job by stabilizing the filament, which helps the lamp keep its output steady over time and cuts down on blackening. Then there’s the R7s connector. It’s a simple bi-pin design that makes installation a breeze. Wire it up, set the alignment, and it locks in place. No adapter plates. No fuss.
Tough Heat, Real-World Reality
These are industrial-grade heaters, no doubt. But that high watt density comes with a reality check: you need proper cooling and clearance around the tube. Give it the space it needs, and you’ll keep ambient heat under control and protect nearby components. When you do it right, you get rapid infrared response, output that stays stable, and fewer headaches from maintenance interruptions.