Let’s talk about the 640mm 2600W Carbon Fiber Heater
We built this 640mm carbon fiber lamp for those messy, high-output drying jobs where quartz or halogen tubes usually just give up. At 2600W, it packs a serious punch across a decent length, so it fits right into most industrial drying setups without a fuss. Why carbon fiber? Here’s the thing: when you’re pushing 2600W over 640mm, you don’t want “hot spots” that torch your product. Carbon fiber is the secret here. It doesn’t get as ridiculously hot as tungsten, but it puts out more medium-to-long wave infrared. What that actually means for you is that the heat sinks deeper into the material. It doesn’t just sear the surface; it gets inside. Your ramp-up time is faster, which means your whole cycle finishes sooner. It’s built to take a beating Standard filaments are fragile. Carbon fiber isn’t. It can handle the vibrations and the thermal shocks of a busy factory floor without snapping. We wrap the whole thing in high-purity quartz to keep oxygen from eating the element. And unlike halogen lamps that need a complex gas cycle to keep going, this carbon structure is just naturally stable. It’s simpler. It lasts. A few things to watch out for You’ll need a rock-solid power supply for this. 2600W is a lot of juice. Double-check your wiring and contactors before you flip the switch—you really don’t want to deal with a melted terminal. Now, be honest about what you need. If you’re looking for a split-second “flash-off” on the very surface of a part, this might feel a bit slow. Shortwave halogen is better for that. But for deep-drying and curing? This is exactly the tool you want. One last tip: take a look at your reflectors. If they’re dirty or pitted, you’re basically throwing away 20% of your power. Keep them clean, and you’ll get every bit of that 2600W.